Cutting on Professional Infrared Heater Experts

Laser cutting support heater

Fri, 17 Jul 2026 02:50:03 +0800

Stop Wasting Power on Your Glass Annealing

Let’s be honest: annealing is usually the biggest energy hog in the entire production line. Most old-school heating setups spend way too much time heating up the air around the glass instead of actually heating the glass itself. It’s a waste of money. We handle this differently. By using shortwave infrared (IR) lamps, we aim the heat directly at the material. It cuts out that annoying thermal lag and, more importantly, knocks a decent chunk off your annual power bill.

Thermal stress glass cutting

Sun, 12 Jul 2026 07:33:38 +0800

Getting Low-E Glass Heating Right (When You’re Dealing With Huge Sheets)

If you’ve ever worked with Low-E glass, you know the anxiety of the stress cutting process. One wrong move with the thermal gradient and—crack—there goes your sheet. When you’re dealing with glass wider than 3 meters, you can’t just buy a few lamps off a shelf and hope for the best. That’s a recipe for disaster. We build custom, ultra-long infrared heating units because those wide gaps are where things usually go wrong.

PVB film cutting heating

Mon, 06 Jul 2026 05:49:51 +0800

Introduction

We built this shortwave infrared heater for one reason: to dry PVB film during cutting without eating up your whole shop floor. If you’re running a screen printing glass line, you want heat that fits your space—not heat that forces you to rebuild the line around it.

Technical Deep-Dive

Here’s the heart of it: we packed serious heat into a small package. It runs on 400V, so we can deliver high power in a short envelope. That means it ramps up fast and responds fast, hitting the exact PVB film drying temps you need the moment you need them. The length is intentional. It gives you enough coverage for the film edge, but stays tight enough to keep your conveyor geometry clean and simple.